US Automatic 030215 Wireless Exit Button

US Automatic 030215 Wireless Push Button

Download Specs

The push-to-operate wireless button operates at 433.92 MHz in AM/ASK modulation. It’s mainly composed by a capacitive touch sensitive circuit and by a radio trans-mitter. It can be used to operate gates, doors or garage doors or any device with the corresponding compatible 433 MHz receiver. The security protocol is fixed with 19683 code combinations.

A special sensor lights the led frame when the hand approaches the device at about 10 cm and triggers the radio transmission when it touches the front surface. The enclosure allows outdoor installations ( IP55). Each product is already factory programmed with a different security code. The transmitter is supplied with a ER14505 lithium battery.

The Button operates when you skim over the external surface with the hand. The sensitivity of the detector can change according to the mounting surface type: metallic surfaces increase the sensitivity but can reduce the range of the radio transmission. Approach the cover or touch it until the buzzer sounds. The RF transmission lasts while the buzzer sounds. Normally it’s necessary to skim over the cover with the hand and not with a single finger.

Programming

Press the receiver P1 button and hold until green LD light comes ON. While LD light is ON place hand on the Push To Operate when the buzzer sounds programming is complete. The receiver LD light must be ON when placing hand on the Push to Operate

Specifications

• Carrier frequency: 433.92 MHz
• Modulation: AM/ASK
• N° channels: 1
• E.r.p.: 300 uW
• Battery type: ER14505 Lithium
• Operating voltage: 3.6 Vdc
• Current consumption: 2 µA : stand-by
• Security protocol: fixed code
• Code combinations: 3exp9
• Typical range in open space: ~200m / ~656 feet
• Operating temperature: -20°/+80°C
• Enclosure IP grade: IP55
• Dimensions (mm): 105 x 70 x 23.5