Linear MGR-1 Gate Receiver

Linear MGR-1 Gate Receiver

The MegaCode series of digital receivers are wireless radio controls designed for use with automatic gate openers or garage door operators. The MegaCode radio format provides unparalleled security. The transmitter and receiver can be programmed to more than a million different codes.

MegaCode receivers and transmitters do not contain a typical “coding switch”. Each transmitter is pre-set at the factory to a unique code. The receiver is programmed by sending a signal to it from the transmitter(s) that are going to be used with it. This stores the transmitters code into the receiver’s memory. The receiver will retain its memory even without power. The receiver will activate only from these “memorized” transmitters. Each MegaCode receiver can remember a maximum of 40 transmitters.

The receivers can operate from 12-30 volts AC or 10.5-30 volts DC and are normally powered from the gate operator. The relay contact(s) are rated at 5 amps @ 32 volts AC/DC NEC Class 2 circuit.

The MGR is a 1-Channel Gate Receiver designed for use with automatic gate operators or systems where a remote antenna is needed. The receiver uses the MegaCode radio format with over a million possible code combinations. Up to 40 transmitters can be programmed into the receiver.

Features

• Single Form ”A” (normally open) relay rated at 30 Volts AC/DC up to 5 Amps
• Supplied with whip antenna, three feet of coaxial cable, and bulkhead connector
• Memory: storage for up to 40 MegaCode transmitters
• Power: 12 – 30 VAC or 10.5 – 30 VDC
• Codes: 1,000,000+ (MegaCode format)
• RF frequency: 318 MHz
• Dimensions: 3.625″ W x 5.25″ H x 1.5″ D
• Also known as DNR00104